2007 Yamaha Motorsports Virago 250 Owners Manual - Page 72
2007 Yamaha Motorsports Virago 250 Manual
Page 72 highlights
PERIODIC MAINTENANCE AND MINOR REPAIR 1. Wheel axle 2. Front wheel axle pinch bolt 1. Speedometer gear unit 6 3. Lift the front wheel off the ground according to the procedure on page 6-35. 4. Pull the wheel axle out, and then remove the wheel. ECA11070 2. Lift the wheel up between the fork legs. NOTE: Make sure that there is enough space between the brake pads before inserting the brake disc and that the slot in the speedometer gear unit fits over the retainer on the fork leg. 1. Speedometer gear unit 2. Retainer 3. Speedometer cable 3. Insert the wheel axle. 4. Lower the front wheel so that it is on the ground. 5. Tighten the wheel axle to the specified torque. Tightening torque: Wheel axle: 59 Nm (5.9 m·kgf, 43 ft·lbf) CAUTION: Do not apply the brake after the wheel has been removed together with the brake disc, otherwise the brake pads will be forced shut. EAU24932 6. Tighten the front wheel axle pinch bolt to the specified torque. Tightening torque: Front wheel axle pinch bolt: 20 Nm (2.0 m·kgf, 14 ft·lbf) To install the front wheel 1. Install the speedometer gear unit into the wheel hub so that the projections mesh with the slots. 6-36