2007 Yamaha Motorsports Rhino 450 Auto. 4x4 Owners Manual - Page 104

2007 Yamaha Motorsports Rhino 450 Auto. 4x4 Manual

Get 2007 Yamaha Motorsports Rhino 450 Auto. 4x4 PDF manuals and user guides View all 2007 Yamaha Motorsports Rhino 450 Auto. 4x4 manuals

Page 104 highlights

EVU00702 Engine oil and oil filter cartridge The engine oil level should be checked before each operation. In addition, the oil must be changed and the oil filter cartridge replaced at the intervals specified in the periodic maintenance and lubrication chart. To check the engine oil level 1. Place the vehicle on a level surface. 2. Remove the console. (See page 8-9 for console removal and installation procedures.) 3. Check the engine oil level on a cold engine. NOTE: If the engine was started before checking the oil level, be sure to warm up the engine sufficiently, and then wait at least ten minutes until the oil settles for an accurate reading. 4. Remove the engine oil filler cap and wipe off the dipstick with a clean rag. 5. Insert the dipstick in the oil filler hole (without screwing it in), and then remove it again to check the oil level. 8-10 NOTE: The engine oil should be between the minimum and maximum level marks. _ _ 1. Maximum level mark 3. Dipstick 2. Minimum level mark 4. Engine oil filler cap 6. If the engine oil is at or below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. 7. Insert the dipstick into the oil filler hole, and then tighten the oil filler cap. 8. Install the console.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
8-10
EVU00702
Engine oil and oil filter cartridge
The engine oil level should be checked before
each operation. In addition, the oil must be
changed and the oil filter cartridge replaced at
the intervals specified in the periodic mainte-
nance and lubrication chart.
To check the engine oil level
1.
Place the vehicle on a level surface.
2.
Remove the console. (See page 8-9 for
console removal and installation proce-
dures.)
3.
Check the engine oil level on a cold engine.
NOTE:
If the engine was started before checking the
oil level, be sure to warm up the engine suffi-
ciently, and then wait at least ten minutes until
the oil settles for an accurate reading.
4.
Remove the engine oil filler cap and wipe
off the dipstick with a clean rag.
5.
Insert the dipstick in the oil filler hole
(without screwing it in), and then remove
it again to check the oil level.
NOTE:
_
The engine oil should be between the mini-
mum and maximum level marks.
_
1.
Maximum level mark
2.
Minimum level mark
3.
Dipstick
4.
Engine oil filler cap
6.
If the engine oil is at or below the mini-
mum level mark, add sufficient oil of the
recommended type to raise it to the cor-
rect level.
7.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8.
Install the console.