2007 Yamaha Motorsports RS Rage GT Owners Manual - Page 84
2007 Yamaha Motorsports RS Rage GT Manual
Page 84 highlights
E_8gg.book Page 29 Thursday, March 16, 2006 4:23 PM ESU04092 Adjusting the control rods The weight transfer can be adjusted by turning the control rod adjuster or adjusting nut. For RS90R/RS90GT/RSG90/RSG90GT 1. Loosen the locknut 1. 2. Turn the control rod adjuster 2 in direction a to increase weight transfer or direction b to decrease weight transfer. CD-27E Adjuster turning direction Weight transfer a Increased ← ← → b → Decreased 3. Check the adjuster length c using the scale on the special wrench 3 included in the owner's tool kit as shown. Make sure that the rim d of the control rod body is within the range e of the scale. 4. Tighten the locknut while holding the adjuster in place. Locknut tightening torque: 35 Nm (3.5 m·kgf, 25 ft·lb) CAUTION: @ When using the special wrench, make sure that it is situated at a right angle to the control rod, and that it is tightly fitted to the locknut or the control rod adjuster. @ WARNING @ Never adjust the control rod beyond the range of the scale on the special wrench. @ 8-29