2007 Yamaha Motorsports Grizzly 350 Owners Manual - Page 106
2007 Yamaha Motorsports Grizzly 350 Manual
Page 106 highlights
EWB01900 WARNING POTENTIAL HAZARD Using low-flash-point solvents or gasoline to clean the sponge material. WHAT CAN HAPPEN Low-flash-point solvents or gasoline can catch fire or explode. HOW TO AVOID THE HAZARD Use parts cleaning solvent to clean the sponge material. 6. Squeeze the excess solvent out of the sponge material and let it dry. ECB00440 9. Pull the sponge material over the air filter element frame, and then install the lock plate. 10. Insert the air filter element into the air filter case, and then install the air filter case cover by hooking the holders onto the air filter case. 11. Install the seat. NOTE: The air filter element should be cleaned every 20- 40 hours. It should be cleaned and lubricated more often if the ATV is operated in extremely dusty areas. Each time the air filter element maintenance is performed, check the air inlet of the air filter case for obstructions. Check the air filter case rubber joint to the carburetor fittings and the rubber joint manifold fittings for an air-tight seal. Tighten all fittings securely to avoid the possibility of unfiltered air entering the engine. ECB00460 8 CAUTION: Do not twist the sponge material when squeezing it. 7. Check the sponge material and replace it if damaged. 8. Apply Yamaha foam air filter oil or other quality foam air filter oil to the sponge material. NOTE: The sponge material should be wet but not dripping. 8-20 CAUTION: Make sure that the air filter element is properly seated in the air filter case. G Never operate the engine with the air filter element removed. This will allow unfiltered air to enter the engine, causing rapid engine wear and possible engine damage. Additionally, operation without the air filter element G