2003 Yamaha Motorsports Vino Classic Owners Manual - Page 58
2003 Yamaha Motorsports Vino Classic Manual
Page 58 highlights
SCOOTER CARE AND STORAGE 8 Do not use any harsh chemical products on plastic parts. Be sure to avoid using cloths or sponges which have been in contact with strong or abrasive cleaning products, solvent or thinner, fuel (gasoline), rust removers or inhibitors, brake fluid, antifreeze or electrolyte. 8 Do not use high-pressure washers or steam-jet cleaners since they cause water seepage and deterioration in the following areas: seals (of wheel and swingarm bearings, fork and brakes), electric components (couplers, connectors, instruments, switches and lights), breather hoses and vents. 8 For scooters equipped with a windshield: Do not use strong cleaners or hard sponges as they will cause dulling or scratching. Some cleaning compounds for plastic may leave scratches on the windshield. Test the product on a small hidden part of the windshield to make sure that it does not leave any marks. If the windshield is scratched, use a quality plastic polishing compound after washing. After normal use Remove dirt with warm water, a mild detergent, and a soft, clean sponge, and then rinse thoroughly with clean water. Use a toothbrush or bottlebrush for hard-to-reach areas. Stubborn dirt and insects will come off more easily if the area is covered with a wet cloth for a few minutes before cleaning. After riding in the rain, near the sea or on salt-sprayed roads Since sea salt or salt sprayed on the roads during winter are extremely corrosive in combination with water, carry out the following steps after each ride in the rain, near the sea or on salt-sprayed roads. NOTE: Salt sprayed on roads in the winter may remain well into spring. 1. Clean the scooter with cold water and a mild detergent after the engine has cooled down. 7 cC ECA00012 Do not use warm water since it increases the corrosive action of the salt. 2. Apply a corrosion protection spray on all metal, including chrome- and nickel-plated, surfaces to prevent corrosion. 7-2