2013 Volvo C70 Owner's Manual - Page 229

09 Maintenance and servicing Replacing bulbs Low beam bulb 09 5. Disconnect the wiring connector by pressing down the clip with your thumb while at the same time pulling the connector with your other hand. 6. Lift out the headlight housing and place it on a soft surface to avoid scratching the lens. Low beam bulb Cover with retaining clamps Installing a new bulb 1. Insert the new bulb. It can only be installed in one position. 2. Press the retaining spring inward and upward and slightly to the right until it snaps into place. 3. Press the wiring connector onto the bulb. 4. Put the plastic cover in place. 5. Press the retaining clamps back into place. 1. Open the hood and remove the headlight housing (see page 226 for instructions). 2. Release the retaining clamps on the cover and remove it. 3. Release the bulb's retaining spring holding the bulb in place by pressing it first to the left to release it and then moving it outward and downward. 4. Pull out the bulb. CAUTION When disconnecting the connector, pull on the connector itself and not on the wiring. After the defective bulb has been replaced, reinsert the housing in the reverse order. Check that the retaining pin is correctly inserted. 6. Reinstall the headlight housing (see page 226). 227