2013 Volvo C70 Owner's Manual - Page 104
2013 Volvo C70 Manual
Page 104 highlights
04 Interior Front seats Move this section of the control up or down to raise/lower the front section of the seat cushion. Move the control forward/rearward to move the seat forward or rearward. Move this section of the control up or down to raise/lower the rear section of the seat cushion. Backrest tilt. 04 Emergency stop If the seat inadvertently begins to move, press any of the buttons to stop the seat. 1. Adjust the seat (and door mirrors) to the desired position. 2. Press and hold down the "M" (Memory) button. 3. With the "M" button depressed, press memory button 1 to store the seat and mirrors' current position. To move the seat and mirrors to the position that they were in when memory button 1 was programmed, press and hold down button 1 until the seat/mirrors stop moving. As a safety precaution, the seat will stop automatically if the button is released before the seat has reached the preset position. Programming the seat memory, driver's seat only* NOTE Both front seats are equipped with head restraints that can be adjusted vertically to suit the height of the passenger. The upper edge of the head restraint should be at least on a level with the upper-most point of the seat occupant's ear (see the section "Adjusting the front seat head restraints" on page 103). Power seat memory buttons G020200 Central locking system remote key and driver's seat memory The remote key transmitter can also be equipped with an optional function that controls the electrically operated driver's seat in the following way: 1. Adjust the seat/door mirrors to the desired position. 2. When you leave the car, lock it using the remote key. 3. The next time the driver's door is unlocked with the same remote key and that door is opened within 2 minutes, the driver's seat NOTE The power seats have an overload protector that activates if a seat is blocked by any object. If this occurs, switch off the ignition (key in position 0) and wait for approximately 20 seconds before operating the seat again. Three different seating positions (and the position of the door mirrors) can be stored in the seat's memory. The memory buttons are located on the outboard side of the driver's seat (see the illustration). To program (store) a seat/mirror position in memory button 1: 102 * Option/accessory, for more information, see Introduction.