2012 Volvo S60 Owner's Manual - Page 307
2012 Volvo S60 Manual
Page 307 highlights
08 Maintenance and specifications Replacing bulbs CAUTION Never touch the glass of bulbs with your fingers. Grease and oils from your fingers vaporize in the heat and will leave a deposit on the reflector, which will damage it. Remove the headlight housing by alternatively pulling the front and rear edges until it can be lifted out. Reinserting the headlight housing CAUTION When disconnecting the connector, pull on the connector itself and not on the wiring. NOTE • • Always switch off the ignition before starting to replace a bulb. The optional Active Bending Light bulbs contain trace amounts of mercury. These bulbs should always be disposed of by a trained and qualified Volvo service technician. 4. (Lower illustration under "Headlight housing") Unplug the wiring connector by holding down the clip with your thumb. Pull out the connector with the other hand. 5. Lift out the housing and place it on a soft surface to avoid scratching the lens. 6. Replace the defective bulb(s). 1. Plug in the connector until it clicks into place. 2. Reinstall the headlight housing and locking pins. The short locking pin should be closest to the grille. Check that they are correctly inserted. The headlight housing must be properly inserted and secured in place before the lighting is switched on or the remote key is inserted into the ignition slot. 3. Check that the lights function properly. Removing the headlight housing 1. Switch off the ignition by briefly pressing the START/STOP ENGINE button. 2. Remove the remote key from the ignition slot1. 3. (Upper illustration under "Headlight housing") Withdraw the headlight housing's locking pins. 08 1 Does not apply to vehicles with the optional keyless drive. `` 307