2010 Volvo XC90 Owner's Manual - Page 66
2010 Volvo XC90 Manual
Page 66 highlights
02 Instruments and controls Left-side steering wheel lever Lever positions 02 Turn signals When turning Move the lever as far up or down as possible (to position 2) to start the turn signals. The turn signals will be cancelled automatically by the movement of the steering wheel, or the lever can be returned to its initial position by hand. High/low beam headlights Continuous high beams 1. Turn the ignition key to position II. 2. With the light switch in position , (see page 63) pull the turn signal lever toward the steering wheel to toggle between high and low beams. When changing lanes The driver can automatically flash the turn signals 3 times by: High beam flash 1. Turn the ignition key to position II. 2. Pull the turn signal lever to position (3). The high beams will remain on until the lever is released. • Moving the turn signal lever up or down to G026954 position (1) and releasing it. • Moving the lever up or down to position (2) and immediately back to its original position. Turn signals, lane change position Turn signals, position for normal turns High beam flash Toggle between high and low beams, Home Safe lighting Home safe lighting When leaving your vehicle at night, home safe lighting can illuminate the area in front of the vehicle. 1. Remove the key from the ignition switch. 2. Pull the turn signal lever as far as possible toward the steering wheel and release it. 3. Exit the vehicle and lock the doors. The headlights and parking lights will illuminate and remain on for 301, 60 or 90 seconds. The time interval can be changed by a trained and qualified Volvo service technician. NOTE • • This automatic flashing sequence can be interrupted by immediately moving the lever in the opposite direction. If the turn signal indicator flashes faster than normal, check for a burned-out turn signal bulb. 1 Factory setting 66