2009 Volvo XC90 Owner's Manual - Page 182
2009 Volvo XC90 Manual
Page 182 highlights
07 Wheels and tires Changing wheels 5. Continue to raise the wheel by turning the crank clockwise. Raise the wheel a little bit at a time and guide it around the rear axle until it is securely seated in the storage area. 6. When it is no longer possible to turn the crank any further, check that the spare wheel is securely in position in the storage compartment. WARNING There is an attachment point on each side of the vehicle located under the pillars between the front and rear doors. This point is used during the production process only, and is NOT intended for attaching the jack. Changing a wheel • Park the vehicle on a firm, level, non-slippery surface. • Engage the parking brake and put the gear selector in the Park position. • Loosen the wheel bolts by exerting downward pressure on the lug wrench. • Remove the wheel cap (where applicable) using the lug wrench in the tool bag. • With the wheels still on the ground, use the lug wrench to loosen the wheel bolts 1/2 - 1 turn. Turn the bolts counterclockwise to loosen the bolts. CAUTION • G020332 G026997 The vehicle must not be driven with wheels of different dimensions or with a spare tire other than the one that came with the vehicle. The use of different size wheels can seriously damage your vehicle's transmission. Correct tightening torque on wheel bolts must be observed. The wheel bolts should never be greased or lubricated. Extended, chromed wheel bolts must not be used with steel rims, as they make it impossible to fit the hub caps. 07 WARNING The undersides of accessory running boards are not intended for attaching the jack. • • • Jack attachment points Jack attachments There are two attachment points for the jack on each side of the vehicle. These attachment points are under the center of each door. 182