2006 Volvo V70 Owner's Manual - Page 49
2006 Volvo V70 Manual
Page 49 highlights
Audible alarm signal An audible alarm signal is given by a battery powered siren. One alarm cycle lasts for 25 seconds. "Panic" button In an emergency situation, this feature can be used to attract attention. Activate the "panic" function by pressing the red button on the remote control (see illustration on page 81) for at least 3 seconds or by pressing this button twice within 3 seconds. The turn signals will flash, the interior lights will go on and the car's horn will sound. The function can be turned off by pressing any of the buttons on the remote control or will stop automatically after 25 seconds. When a button is pressed, there is a 5 second delay before the panic alarm is deactivated. NOTE: This function will NOT unlock the car. pg. 85 Alarm Temporarily turning off the inclination and movement alarm sensor(s) - accessory This button will only be found in cars equipped with the accessory inclination and/or movement sensors. FCC ID: MAYDA5823 This device complies with part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Canadian IC: 4405A-DA5823 Movement sensor DA5823 by Dynex Operation is subject to the following conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. In certain situations it may be desirable to turn off the inclination and movement alarm sensors if, for example, you drive your car onto a ferry where the rocking of the boat could trigger the alarm or if a pet is left in the car with the doors locked. To temporarily turn off the inclination and movement alarm sensors from the alarm system: From the time the ignition key is turned from the Drive position (position II) until you lock the car, you can press the button in the center console. The LED in the switch will light up and a message will be displayed in the text window