2013 Polaris High-Ball Owners Manual - Page 68
2013 Polaris High-Ball Manual
Page 68 highlights
Maintenance Seat Removal (HAMMER S) WARNING! A loose seat could cause a sudden shift in riding position, causing loss of control. Always ensure seats are secure before riding. Seat Screws 1. Remove the passenger seat cowl by pulling evenly and directly upward on both sides of the cowl. 2. Remove the (3) socket head seat screws using a 5 mm hexagonal wrench. 3. Lift the rear of the seat and pull rearward to disengage the tab at the front of the seat. Seat Installation (HAMMER S) 1. Slide the seat tongue into the receiver at the rear of the fuel tank. Align the seat screw holes. Ensure the front seat mount is engaged in the front receiver, then install the screws. Torque to 57 in. lbs. (6.8 Nm). 2. Reinstall the passenger seat cowl. Seat Removal (JACKPOT) WARNING! A loose seat could cause a sudden shift in riding position, causing loss of control. Always make sure the seats are securely fastened before riding the motorcycle. 2 1 1. Remove the side covers. 2. If necessary, remove the fuse box from the bracket. 3. Remove the three screws securing the seat to the frame. Lift the rear of the seat and pull rearward and upward to remove it. Seat Installation (JACKPOT) 1. Slide the seat tongue into the rubber mount at the rear of the fuel tank. Push down on the rear of the seat until the screw holes align. 2. Ensure the front seat mount is engaged in the front rubber mount, then install the screws and tighten securely. 3. Reinstall the fuse box (if removed). Reinstall the side covers. 2 1 Seat Removal (JUDGE/BOARDWALK) 1. Remove the side covers. Remove the fuse box from the bracket. 2. Remove the two screws securing the seat to the frame. Remove the four screws securing the rear fender rails and remove the fender rails. Loosen the four screws securing the rear seat bracket to the frame. 3. Carefully lift the seat upward and forward until the rear bracket fingers are freed from the four rear mounting screws. Seat Installation (JUDGE/BOARDWALK) 1. Carefully lower the front of the seat and align the four slotted rear bracket fingers with the four rear mounting screws. Make sure the fingers are outside of the spacers. Then carefully pull the seat rearward so the screws can support the slotted fingers without holding on to the seat. 2. Adjust the seat so the front screw holes align. Install the screws and tighten securely. 3. Tighten the four rear screws securing the rear seat bracket to the frame. 4. Reinstall the rear fender rails. Install the screws and tighten securely. 66