2011 Polaris Turbo IQ LX Owners Manual - Page 58
2011 Polaris Turbo IQ LX Manual
Page 58 highlights
THE PERFECT FIT IQ/LX Rear Suspension Adjustments Initial Spring Preload Setting (Sag Method) To set up the rear suspension torsion spring preload, measure the distance between the ground and rear bumper. This is measurement X. Take the first measurement with no rider and with the rear suspension at full extension. Tip: The rear bumper may need to be lifted upward slightly to fully extend the rear suspension. X Next, have the rider drop down hard on the seat and bounce up and down several times, collapsing the rear suspension. With the rider seated, measure the distance between the ground and the rear bumper at the exact location used for measurement X. This is measurement Y. Y To determine sag, commonly referred to as ride-in, subtract measurement Y from X (sag=X-Y). If the measured sag is incorrect, adjust the FRA position and/or rear torsion spring preload. Suspension Recommended Sag IQ 121 LX 136 4-5 inches (10-13 cm) 4-5 inches (10-13 cm) Adjustment Torsion Spring Preload Torsion Spring Preload See Page 55 55 Tip: This is only an initial setup, and final spring preload may vary based on rider preference and riding conditions. 54