2007 Polaris Ranger 500 4x4 Owners Manual - Page 95
2007 Polaris Ranger 500 4x4 Manual
Page 95 highlights
MAINTENANCE Battery Battery Installation Using a new battery that has not been fully charged can damage the battery and result in a shorter life. It can also hinder vehicle performance. Follow the battery charging instructions on page 94 before installing the battery. 1. Ensure that the battery is fully charged. 2. Place the battery in the battery holder. 3. With conventional batteries, install the battery vent tube (sealed batteries do not have a vent tube). NOTE: The vent tube must be free of obstructions and securely installed. Route the tube away from the frame and vehicle body to prevent contact with electrolyte. WARNING Battery gases could accumulate in an improperly installed vent tube and cause an explosion, resulting in serious injury or death. Always ensure that the vent tube is free of obstructions and is securely installed as recommended. 4. On conventional batteries, coat the terminals with dielectric grease or petroleum jelly. 5. Connect and tighten the red (positive) cable first. 6. Connect and tighten the black (negative) cable last. 7. Verify that cables are properly routed. 92