2015 Ducati Monster 821 Owners Manual - Page 98
2015 Ducati Monster 821 Manual
Page 98 highlights
LAP recording With the LAP function "active", it is possible to record the Lap time. To record the lap time it is necessary to activate the LAP TIME function through the Setting Menu in the LAP page. After enabling this function, lap time can be recorded as follows: the first time the rider presses button (3), the "timer" of the first lap starts and "START LAP" will be displayed flashing for 4 seconds in MENU 1: then the previous function will be displayed automatically; from this moment, whenever button (3) is pressed, the Instrument panel will automatically show the lap time in MENU 1 for 10 seconds and the LAP "number" instead of the engine coolant temperature indication: after 10 seconds it will display the previous function. - 30 laps max. can be recorded. If the instrument panel "memory" is full, whenever button (3) is pressed, the instrument panel does not record any lap time and "FULL -- LAP" will be displayed flashing for 4 seconds until lap times are reset. This 96 indication will be displayed until all times are reset with the LAP erase function in the Setting Menu (ERASE). When the "LAP" function is disabled, the current "lap" is not recorded. If the LAP function is enabled and vehicle is suddenly stopped (Key-Off), the function will be automatically disabled (even if timer was active, the current "lap" would not be recorded). If the time is never "stopped", it will roll over upon reaching 9 minutes, 59 seconds and 99 hundredths; the lap timer starts counting from 0 (zero) and will keep running until the recording function is disabled. If, on the contrary, the LAP function is enabled and "memory" was not reset, but recorded laps are less than 30 (example: 18 recorded laps) the Instrument Panel records any left lap until memory is full (in this case 12 further laps can be recorded). In this function only the lap times being recorded are displayed; other data are anyway recorded (MAX speed, MAX rpm and limiter if reached), and can be later displayed in the "Stored LAPs displaying" function (LAP REC) in the Setting Menu.