Hunter 30057 Owner's Manual - Page 3

3 Setting Up Your Air Purifier 1. Remove your air purifier from the box and take it out of the clear plastic protective bag. 2. Place your HEPAtech® Air Purifier on a firm, flat floor. 3. Before turning the Air Purifier 'on,' open the front grill. • For Model 30057A, 30061: To release the front grill, press the buttons on the side until the front grill slides easily over the buttons. (Refer to Figure 1.) • For Model 30067A, 30124A: To release the front grill, place your fingers behind the tabs and pull forward. (Refer to Figure 2.) 4. Next, check the HEPAtech® filter by pressing firmly on all four corners of the filter to ensure that it is fully inserted into the filter opening. 5. The carbon pre-filter is mounted inside of the front grill with "hook" tape. Confirm that it covers the grill vents. (Refer to Figure 3.) 6. Place the filter installation reminder sticker on the inside edge of the front grill. Circle the month and write the year of installation for the pre-filter and HEPAtech® filter. 7. Replace the filter and front grill. Be sure that the bottom grill tabs are in position first, and then push the top of the grill forward until it is closed. The unit is now ready for normal operation. NOTE: This unit will not operate unless the door is placed in the correct position. 8. Plug the unit into a 120V electrical outlet. AIR PURIFIER PARTS HEPAtech® Filter HEPAtech® Filter Front Pre-Filter Grill Front Pre-Filter Grill Buttons for opening the front grill Figure 1 - Model 30057A, 30061 Figure 3 ©2010 Hunter Fan Company Tabs for opening the front grill Figure 2 - Model 30067A, 30124A Hook Tape Grill Vents Hook Tape 08/18/2010