Dell PowerEdge 2950 Hardware Owner's Manual (PDF) - Page 31
See Using the System Setup, See Using the System Setup Program - not booting to cd
View all Dell PowerEdge 2950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Table 1-7. System Messages (continued) Message Memory address line failure at address, read value expecting value Causes Corrective Actions Faulty or improperly installed memory See "Troubleshooting System Memory" modules. on page 120. Memory double word logic failure at address, read value expecting value Memory odd/even logic failure at address, read value expecting value Memory write/read failure at address, read value expecting value Memory tests terminated by POST memory test terminated by keystroke. pressing the spacebar. No boot device available Faulty or missing optical/diskette drive subsystem, hard drive, or harddrive subsystem, or no boot disk in drive A. No boot sector on hard drive Incorrect configuration settings in System Setup program, or no operating system on hard drive. No timer tick interrupt Northbound merge error The following DIMM has been disabled by BIOS: DIMM x Not a boot diskette Faulty system board. The specified DIMM was unable to establish a successful data link with the memory controller. No operating system on diskette. Information only. Use a bootable diskette, CD, or hard drive. If the problem persists, see "Troubleshooting a Diskette Drive" on page 121, "Troubleshooting an Optical Drive" on page 123, and "Troubleshooting a Hard Drive" on page 124. See "Using the System Setup Program" on page 37 for information on setting the order of boot devices. Check the hard-drive configuration settings in the System Setup program. See "Using the System Setup Program" on page 37. If necessary, install the operating system on your hard drive. See your operating system documentation. See ""Getting Help" on page 147." See "Troubleshooting System Memory" on page 120. Use a bootable diskette. About Your System 31