Dell PowerEdge 2950 Hardware Owner's Manual (PDF) - Page 106
Installing the Control Panel Assembly, Remove the display module from the chassis cutout. - driver
View all Dell PowerEdge 2950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
b Using a T10 Torx driver, remove the two screws that secure the display module to the system chassis. c Remove the display module from the chassis cutout. Figure 3-35. Control Panel Removal 5 4 3 6 2 1 7 1 display module label 4 display module cable 7 control-panel circuit board securing screws (3) 2 display module securing screws (2) 5 control panel cable 3 display module 6 control panel circuit board Installing the Control Panel Assembly 1 Insert the display module into the chassis cutout and secure with the two Torx screws. 2 Affix the display module label to the display module. 3 Install the control panel board in the system chassis and secure with the three Phillips screws. See Figure 3-35. 106 Installing System Components
106
Installing System Components
b
Using a T10 Torx driver, remove the two screws that secure the display module to the system
chassis.
c
Remove the display module from the chassis cutout.
Figure 3-35.
Control Panel Removal
Installing the Control Panel Assembly
1
Insert the display module into the chassis cutout and secure with the two Torx screws.
2
Affix the display module label to the display module.
3
Install the control panel board in the system chassis and secure with the three Phillips screws. See
Figure 3-35.
5
6
2
1
3
4
7
1
display module label
2
display module securing
screws (2)
3
display module
4
display module cable
5
control panel cable
6
control panel circuit board
7
control-panel circuit board
securing screws (3)