Zenith SL-6202 User Guide - Page 3

Code and Tune Settings Code Settings Note: Most installations will not require you to change any jumpers or dip switch settings on your chime and push button. WARNING: Disconnect chime unit from power source before opening code access door. Close door and replace screw before reconnecting to power (if applicable). The push button and chime communicate by using a code that can be changed by switching dip switch positions (or removing and/or adding jumpers) on both the push button and chime. The code is factory set; however, there are 128 selectable codes that allow you to expand your system and prevent outside interference. Other wireless products may cause interference and the system may not function properly. Follow the instructions below for setting a new code. 1. Unplug wireless chime (if applicable). 2. Open the cases and locate the jumpers or dip switches on both the push button and chime (See illustrations on pages 5 and 6). 3. The push button and chime both have eight different jumper/dip switch locations. Positions 1 through 7 are used for setting the code. 4. To change the code, add and/or remove jumpers or change dip switch setting as needed. It is recommended to only change one setting at a time and then check to see if system is functioning properly. Note: Positions 1 through 7 must be exactly the same for both the push button and chime for this system to function. 598-1105-06 --