Zenith C34W37 Operating Guide - Page 52
Programming the Remote - model
UPC - 044642700201
View all Zenith C34W37 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Programming the Remote The remote control for your HD receiver is a multi-brand or universal remote control. It can be programmed to operate most remote-controllable devices of other manufacturers. Note that the remote control may not control all models of other brands. 1 Test your remote control. 2 To find out whether your remote control can operate the component without program- ming, turn on the component such as a VCR and press the corresponding mode button (VCR) on the remote control, while pointing at the component. Test the POWER and CH +/- buttons to see if the component responds properly. If not, the remote 4 requires programming to operate the device. 2 Turn on the component to be programmed, then press the corresponding mode button on the remote control. 3 3 Press the POWER and MUTE buttons simultaneously, the remote control is ready to be programmed for the code. 4 There are two ways to find the right code for the component. A. If you press the CH +/- buttons repeatedly, the codes will change one at-a-time. Press the POWER button after each code change. If the right code is found, the device will turn off. B. Enter a code number using the number buttons on the remote. Programming code numbers for the corresponding component can be found on the following pages. Again, if the code is correct, the device will turn off. 5 Press the EXIT button to store the code. 6 Test the remote control functions to see if the component responds properly. If not, repeat from step 2. PAGE 52 tv vcr cable dvd sat mode light power tv/video front comp/dvi ratio signal freeze 12 45 78 dash(-) 0 mute 3 6 9 flashbk surf audio vol video ch pip pipch- pipch+ pip input info timer cc swap menu exit play pause stop record rew ff skip 3/4 4 5 206-03890