Zanussi ZWF825B4DG User Manual - Page 20

At The End Of The Programme

Page 20 highlights

THE AUTOSENSE SYSTEM LOAD DETECTION After touching the Start/Pause button: 1. The AutoSense System starts estimating the weight of the load to calculate the real programme duration. During this phase the display shows the simple animation. 2. After about 10-15 minutes new cycle duration is displayed. The appliance automatically adjusts the programme duration to the load to achieve perfect washing results in the minimum possible time. INTERRUPTING A PROGRAMME AND CHANGING THE OPTIONS You can change only some options before they operate. 1. Press . The indicator flashes. 2. Change the options. 3. Press again. The programme continues. CANCELLING A RUNNING PROGRAMME 1. Turn the programme knob to position to cancel the programme and to deactivate the appliance. 2. Turn the programme knob again to activate the appliance. Now, you can set a new washing programme. Before starting the new programme the appliance could drain the water. In this case, make sure that the detergent is still in the detergent compartment, if not fill the detergent again. OPENING THE DOOR WHEN THE DELAY START OPERATES While a delay start operates, the appliance door is locked and the indicator is on. 1. Press to pause the appliance. The indicator starts flashing. 2. Wait about 2 minutes until the door lock indicator stops flashing and goes off. 3. You can open the door. 4. Close the door and press the again. The delay start continues to operate. OPENING THE DOOR WHEN THE PROGRAMME OPERATES While a programme operates, the appliance door is locked and the indicator is on. CAUTION! If the temperature and level of the water in the drum are too high, you cannot open the door. 1. Turn the programme knob to position to deactivate the appliance. 2. Wait for some minutes and then open the appliance door. 3. Close the appliance door. 4. Set the programme again. AT THE END OF THE PROGRAMME • The appliance stops automatically. • The acoustic signal operates (if it is activated). • In the display comes on. • The indicator of the goes off. • The door lock indicator flashes for a few minutes, then goes off. • You can open the door. • Remove the laundry from the appliance. Make sure that the drum is empty. • Close the water tap. • Turn the programme knob to position to deactivate the appliance. • Keep the door ajar, to prevent the mildew and odours. The washing programme is completed, but there is water in the drum: • The drum turns regularly to prevent the creases in the laundry. • The door lock indicator is on. The indicator flashes. The door stays locked. • You must drain the water to open the door. To drain the water: 1. Press . The appliance drains the water and spins. 2. When the programme is completed, the door lock indicator flashes for a few minutes. When it goes off, you can open the door. 3. Turn the programme knob to position to deactivate the appliance. The appliance drains and spins automatically after approximately 18 hours (except for Wool programme). 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

THE AUTOSENSE SYSTEM LOAD
DETECTION
After touching the Start/Pause
button:
1.
The AutoSense System starts estimating the
weight of the load to calculate the real
programme duration. During this phase the
display shows the simple animation.
2.
After about 10-15 minutes new cycle duration
is displayed.
The appliance automatically adjusts the
programme duration to the load to achieve
perfect washing results in the minimum
possible time.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1.
Press
.
The indicator
flashes.
2.
Change the options.
3.
Press
again.
The programme continues.
CANCELLING A RUNNING PROGRAMME
1.
Turn the programme knob to position
to
cancel the programme and to deactivate the
appliance.
2.
Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not
fill
the detergent again.
OPENING THE DOOR WHEN THE DELAY
START OPERATES
While a delay start operates, the appliance door is
locked and the indicator
is on.
1.
Press
to pause the appliance.
The indicator
starts
flashing.
2.
Wait about 2 minutes until the door lock
indicator
stops
flashing
and goes off.
3.
You can open the door.
4.
Close the door and press the
again.
The delay start continues to operate.
OPENING THE DOOR WHEN THE
PROGRAMME OPERATES
While a programme operates, the appliance door is
locked and the indicator
is on.
CAUTION!
If the temperature and
level of the water in the drum are too
high, you cannot open the door.
1.
Turn the programme knob to position
to
deactivate the appliance.
2.
Wait for some minutes and then open the
appliance door.
3.
Close the appliance door.
4.
Set the programme again.
AT THE END OF THE PROGRAMME
The appliance stops automatically.
The acoustic signal operates (if it is activated).
In the display
comes on.
The indicator of the
goes off.
The door lock indicator
flashes
for a few
minutes, then goes off.
You can open the door.
Remove the laundry from the appliance. Make
sure that the drum is empty.
Close the water tap.
Turn the programme knob to position
to
deactivate the appliance.
Keep the door ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
The drum turns regularly to prevent the creases
in the laundry.
The door lock indicator
is on. The indicator
flashes.
The door stays locked.
You must drain the water to open the door.
To drain the water:
1.
Press
. The appliance drains the water and
spins.
2.
When the programme is completed, the door
lock indicator
flashes
for a few minutes.
When it goes off, you can open the door.
3.
Turn the programme knob to position
to
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
20