Zanussi ZKHNL3X1 User Manual - Page 18

How to replace: Lamp, ENGLISH

Page 18 highlights

Step 3 Close the oven door to the first opening position (approximately 45° angle). Hold the door with one hand on each side and pull it away from the oven at an upwards angle. Put the door with the outer side down on a soft cloth on a stable surface. 45° Step 4 Hold the door trim (B) on the top edge of the door at the two sides and push inwards to release the clip seal. 2 Step 5 Pull the door trim to the front to re‐ move it. B Step 6 Hold the door glass panels on their top edge one by one and pull them 1 up out of the guide. Step 7 Clean the glass panel with water and soap. Dry the glass panel care‐ fully. Do not clean the glass panels in the dishwasher. Step 8 After cleaning, do the above steps in the opposite sequence. Step 9 Install the smaller panel first, then the larger and the door. Make sure that the glasses are inserted in the correct position otherwise the surface of the door may overheat. 11.4 How to replace: Lamp WARNING! Risk of electric shock. The lamp can be hot. Step 1 Turn off the oven. Wait until the oven is cold. Before you replace the lamp: Step 2 Step 3 Disconnect the oven from the mains. Put a cloth on the bottom of the cav‐ ity. 18 ENGLISH

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

Step 3
Close the oven door to the first
opening position (approximately 45°
angle). Hold the door with one hand
on each side and pull it away from
the oven at an upwards angle. Put
the door with the outer side down
on a soft cloth on a stable surface.
45°
Step 4
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
1
2
B
Step 5
Pull the door trim to the front to re‐
move it.
Step 6
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
Step 7
Clean the glass panel with water
and soap. Dry the glass panel care‐
fully. Do not clean the glass panels
in the dishwasher.
Step 8
After cleaning, do the above steps
in the opposite sequence.
Step 9
Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise the surface of the door
may overheat.
11.4 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Before you replace the lamp:
Step 1
Step 2
Step 3
Turn off the oven. Wait until the
oven is cold.
Disconnect the oven from the
mains.
Put a cloth on the bottom of the cav‐
ity.
18
ENGLISH