Zanussi ZCV66250XA User Manual - Page 19
Troubleshooting
View all Zanussi ZCV66250XA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
A 2 1 2. Pull up the trim. 3. Remove the glass panels. To replace the glass panels, do the same steps in reverse. Before you lower the trim, attach the A trim part to the door. Refer to the image. TROUBLESHOOTING REPLACING THE LAMP WARNING! Risk of electric shock. The lamp can be hot. 1. Turn off the oven. Wait until the oven is cooled down. 2. Disconnect the oven from the mains. 3. Put a cloth on the bottom of the cavity. The back lamp The lamp glass cover is at the back of the cavity. 1. Turn the lamp glass cover counterclockwise to remove it. 2. Clean the glass cover. 3. Replace the oven lamp with a suitable 300 °C heat-resistant oven lamp. Use the same oven lamp type. 4. Install the glass cover. WARNING! Refer to Safety chapters. WHAT TO DO IF... Problem You cannot activate the appliance. You cannot activate the appliance. Residual heat indicator does not come on. The oven does not heat up. The oven does not heat up. The oven does not heat up. Possible cause Remedy The appliance is not connected to an electrical supply or it is connected incorrectly. The fuse is blown. The zone is not hot because it operated only for a short time. The oven is deactivated. The clock is not set. The necessary settings are not set. Check if the appliance is correctly connected to the electrical supply. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician. If the zone operated sufficiently long to be hot, speak to an Authorised Service Centre. Activate the oven. Set the clock. Make sure that the settings are correct. 19