Zanussi ZBB28651SV User Manual - Page 9

WHAT TO DO IF... Problem Possible cause Solution The appliance does not operate. The appliance is noisy. The lamp does not work. The compressor operates continually. There is too much frost and ice. The compressor does not start immediately after pressing the "QuickFreeze", or after changing the temperature. Water flows on the rear plate of the refrigerator. Water flows inside the refrigerator. The appliance is switched off. The mains plug is not connected to the mains socket correctly. There is no voltage in the mains socket. The appliance is not supported properly. The lamp is in stand-by. The lamp is defective. Temperature is set incorrectly. Many food products were put in at the same time. The room temperature is too high. Food products placed in the appliance were too warm. The door is not closed correctly. The "QuickFreeze" is switched on. The door is not closed correctly or the gasket is deformed/dirty. This is normal, no error has occurred. During the automatic defrosting process, frost melts on the rear plate. Food products prevent the water to flow into the water collector. The water outlet is clogged. Switch on the appliance. Connect the mains plug to the mains socket correctly. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. Check if the appliance stands stable. Close and open the door. Contact the nearest Authorised Service Centre. Refer to "Operation". Wait some hours and then check the temperature again. Refer to climate class chart on the rating plate. Allow food products to cool to room temperature before storing. Refer to "Closing the door". Refer to "QuickFreeze ". Refer to "Closing the door". The compressor starts after a period of time. This is correct. Make sure that food products do not touch the rear plate. Clean the water outlet. 9