Zanussi Z716WT83BI User Manual - Page 10
min. 1.6 must be larger than the external diameter
View all Zanussi Z716WT83BI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
5. Connect the water inlet hose to the cold water tap with 3/4 thread. WARNING! Make sure that there are no leaks from the couplings. Use the hose supplied with appliance. Do not use an extension hose if the inlet hose is too short. Contact the Authorised Service Centre for an inlet hose replacement. Water drainage The drain hose can be connected: Ø 40 mm To a stand pipe with vent-hole Directly into a drain pipe at a height of not less than 60 cm (23.6") and not more than 100 cm (39.3"). The end of the drain hose must always be ventilated , i.e. the inner diameter of the drain pipe (min. 40 mm min. 1.6") must be larger than the external diameter of the drain hose. To a sink spigot Put the drain hose in the spigot and tighten it with the supplied cable tie L. Make sure that the drain hose makes a loop to prevent particles going into the appliance from the sink. max.600 mm 10