Yamaha GX-50 Owner's Manual - Page 38

RECORDING COMPACT DISCS 6 MINI COMPONENT SYSTEM GX-50 1 6 DISC CHANGE OPEN/CLOSE 1 2 DISC 3 LOCATION MUSIC PRESET/TUNING CD A/B/C/D/E USER MEMORY POWER PHONES AUTO/MAN'L DOLBY NR TUNER BAND AUX TAPE 1/2 MODE REC/PAUSE TIMER REC NORMAL HIGH DUBBING TIMER HOUR MIN PLAYBACK 1 2 REC/PLAYBACK PTY SEEK FREQRAPSN/PDTYO/RMT/CT RMEOPDEEAT STEADRTIT DISPLAY VOLUME DOWN UP MEMORY TIME ADJ Active Servo Technology EJECT 34 5 EJECT 2 1 1 6 6 A TIME MODE 2 2 7 7 B PROG REPEAT CD 3 4 5 3 4 5 8 PRESET 8 9 0 C D E TAPE EDIT +I0 RANDOM OPEN/CLOSE TUNER DISC SKIP STOP PLAY/PAUSE LOCATION PLAY STOP PLAY MUSIC TAPE USER SLEEP FLAT REC/PAUSE DECK 1/2 POWER INPUT VOLUME 6 5 1 • When recording important selections, be sure to make a preliminary test to ensure that the desired source material is being properly recorded with good sound quality. • The automatic recording level control circuit automatically controls the level of the input signal used for recording. • Adjusting the VOLUME control and using the built-in sound field processor have no effect on the recorded sound. If, however, the built-in graphic equalizer is used, its effect is recorded along with the source. * Music with an equalizer effect is suitable for listening to inside a car etc. • For the tape deck, the deck which can be used for recording is the deck 2 only. When recording, be sure to load a tape into the deck 2 cassette compartment. • Recording cannot be done if the tape deck is selected as the playback source. CD synchronized recording 1 Press the CD input selector button and load the disc to be recorded. 2 Load a tape into the deck 2 cassette compartment. * Wind past the beginning part of the tape on which recording cannot be performed. 3 When recording with the Dolby NR system, press the DOLBY NR button so that " B" lights up on the display. If not, turn it off. * For details, refer to the "Dolby B Type Noise Reduction" on page 24. 4 If desired, switch the reverse mode by pressing the reverse MODE selector button. When the tape is set so that side A faces you, recording will be done as follows automatically according to the selected reverse mode. Side A only Side A → SideB Side B only Side B only 5 Press the REC/PAUSE button. * "REC" lights up on the display. 6 Start CD playback by pressing the corresponding DISC selector button, or by pressing the play/pause / button if the disc is already selected. * Before CD playback begins, recording automatically begins on the side of the tape now selected. E-28