Whirlpool WFW6620HW Owners Manual - Page 59
If you experience, Possible Causes, Solution, Drying Results
View all Whirlpool WFW6620HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw.. If you experience Drying Results Clothes are not drying satisfactorily or drying times are too long Lint on load Possible Causes The load is too large and heavy to dry quickly. Area under door seal is clogged with lint. On some models: Drain pump filter is clogged with lint. Dried loads are wrinkled The load was not removed from washer at the end of the drying cycle. The washer was tightly packed. Load too hot Load removed before cool-down portion of cycle is complete. Solution Separate the load to tumble freely. Loading drum a quarter full or less will improve drying performance and cycle time. Run a high-speed spin cycle. Gently pull back the rubber door seal and clean lint with the textured side of an affresh Machine Cleaning Wipe. On some models: Clean the drain pump filter. See "Cleaning the Drain Pump Filter/Draining Residual Water." This procedure should be performed occasionally. Remove garments promptly at the end of the drying cycle, or use the FanFresh option. Dry smaller loads that can tumble freely. Loading drum a quarter full or less will improve drying performance and cycle time. Results may also vary depending on fabric type. Allow the drying cycle to complete the cool-down portion of the cycle before removing the load. If you cancel the cycle before the cool-down portion of the cycle and immediately remove the load, it will be very hot. 59