Whirlpool WED9200S Use and Care Manual - Page 9

Style 2: Direct wire strain relief Unscrew the removable conduit connector and any screws from a 3/4"(1.9 cm) UL listed strain relief (UL marking on strain relief). Put the threaded section of the strain relief through the hole below the terminal block opening. Reaching inside the terminal block opening, screw the removable conduit connector onto the strain relief threads. A B A. Removable conduit connector B. Hole below terminal block opening C. Strain relief threads Put direct wire cable through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable. Electrical Connection Options If your home has: And you will be Go to Section connecting to: 4-wire receptacle (NEMA Type 14-30R) A UL listed, 120/ 4-wire connection: 240-volt Power supply cord (_ 4-wire direct (12.7 cm) 3-wire receptacle (NEMA type 10-30R) 30-amp, dryer mpoinwimerumsu, pply cord* A fused disconnect or cboirxc*uit breaker 4-wire connection: Direct Wire A UL listed, 120/ 3-wire connection: 240-volt Power supply cord (_ 3-wire direct 30-amp, dryer mpoinwimerumsu, pply cord* A fused disconnect or 3-wire connection: Direct Wire cboirxc*uit breaker *If local codes do not permit the connection of a cabinet-ground conductor to the neutral wire, go to "Optional 3-wire connection" section. 4-wire connection: Power supply cord IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire connections. 4. Now complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) CD E G A. 4-wire receptacle (NEMA type 14-30R) B. 4-prong plug C. Ground prong D. Neutral prong E. Spade terminals with upturned ends F. 3/4"(1.9 cm) UL listed strain relief G. Ring terminals 1. Remove center silver-colored terminal block screw.