Weslo Momentum 630 Elliptical English Manual - Page 5

ASSEMBLY To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480. Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included tool(s), assembly requires a Phillips screwdriver wrench , and a rubber mallet . , an adjustable As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The second number is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled. M6 Locknut (27)-4 M10 Locknut (33)-6 M10 Split Washer (59)-2 Wave Washer (64)-2 M10 Washer (35)-2 M6 x 18mm Screw (43)-4 M6 x 38mm Button Bolt (50)-4 M10 x 68mm Button Bolt (48)-2 M6 x 45mm Flat Head Screw (36)-4 M10 x 25mm Patch Screw (22)-2 M10 x 75mm Carriage Bolt (34)-4 Pedal Arm Bolt Set (40)-2 1. Identify the Front Stabilizer (10), which is narrower than the Rear Stabilizer (not shown). 1 While another person lifts the front of the Frame (1), 34 attach the Front Stabilizer (10) with two M10 x 75mm Carriage Bolts (34) and two M10 Locknuts 33 (33). 10 1 33 5