Weslo Cadence Dx9 English Manual - Page 8

DIAGRAM OF THE CONSOLE Monitor Display Speed Control Clip Key Pulse Sensor CAUTION: Before operating the console, read the following precautions. • Do not stand on the walking belt when turning on the power. • Always wear the clip (see the drawing above) while operating the treadmill. When the key is removed from the console, the walking belt will stop. • Adjust the speed in small increments. • The training zones marked around the speed control are general guidelines only. See page 14 or more information. • To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle. BATTERY INSTALLATION STEP-BY-STEP CONSOLE OPERATION The console requires two "AA" batteries (not in- Step onto the foot rails of the treadmill. Find the clip cluded). Alkaline batteries are recommended. To in- attached to the key (see the drawing above), and slide stall batteries, open the battery cover as shown below. the clip onto the waistband of your clothing. Test the Press two batteries into the battery compartment, with clip by carefully taking a few steps backward until the negative (-) ends of the batteries touching the the key is pulled from the console. If the key is not springs. Close the battery cover, push up on the tab, pulled from the console, adjust the position of the and then push the tab forward as shown. Be sure that clip as needed. the tab locks into place. 1 Insert the key fully into the power switch. Battery Cover Note: Inserting the key will not turn on the dis- play. The display will turn on when the ON/RESET button is Batteries 8 Battery Cover Tab pressed or when the walking belt is started. (If you just installed batteries, the display will already be on.)