Weslo Cadence Dx12 English Manual - Page 6
Hand tighten a Short Handrail Bolt 15 with a Washer - used
View all Weslo Cadence Dx12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3. Refer to drawing 3a. If there is a plastic tie in the Cage Nut (3) in the Right Handrail (57), remove the plastic tie. Pull 6" of the Wire Harness (26) out of the Right Upright (14). Route the Wire Harness up through the bracket on the Right Handrail and out of the upper end as shown. (If necessary, use needle-nose pliers to grip the end of the Wire Harness.) Thread the included plastic tie through the indicated holes in the Right Handrail. Refer to drawing 3b. Look into the Right Handrail (57) and make sure that the Wire Harness (26) is on the indicated side of the plastic tie. Then, tighten the plastic tie and cut off the end. Refer to drawing 3c. Insert the bracket on the Right Handrail (57) into the right Upright (14), with the lower end of the Right Handrail beside the Extension Leg (41). Hand tighten a Short Handrail Bolt (15) with a Washer (16) into the upper end of the Upright. 4. Attach the lower end of the Right Handrail (57) to the Extension Leg (41) with a Handrail Bolt (59), a Handrail Washer (32), and a Handrail Nut (82) as shown. Do not tighten the Handrail Bolt yet. Note: It may be necessary to push on the lower end of the Handrail to align the hole in the Handrail with the hole in the Extension Leg. Attach the Left Handrail to the left Extension Leg (not shown) as described in steps 3 and 4. Note: There is not a wire harness in the left Upright. 5. Place the Console Base (6) on the Handrails (2, 57). Connect the two Wires (26) to the connectors in the Console Base. Important: Make sure that the Wires are fully inserted. WARNING: Do not disconnect or connect the Wires while the treadmill power cord is plugged in. Thread four Screws (55) into the Handrails (2, 57) and the Console Base (6). After all four Screws have been started, tighten the Screws until they are snug; do not overtighten the Screws. 6. Attach the Storage Latch (12) to the left Upright (14) with two Screws (55). Do not overtighten the Screws. Tighten all of the bolts used in steps 3 and 4. 3a 3c 57 Tie 57 26 3 14 3b Tie 15 16 14 26 57 41 4 57 82 5 57 41 32 59 26 Connectors 6 14 55 6 2 55 12 7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a safe place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill. 6