Weber Summit S-620 LP Owner Manual - Page 30
Handle Light Troubleshooting, Rotisserie Troubleshooting, Sideburner Troubleshooting
View all Weber Summit S-620 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
30 ROTISSERIE TROUBLESHOOTING PROBLEM Rotisserie burner does not light. CHECK Did you hold the burner control knob in and hold in for 20 seconds until after burner ignited? Did you wait to see the entire ceramic surface become alight before counting 20 seconds? Did you repeatedly use the snap ignition until the burner ignited? Does the igniter work (Do you see a spark when you repeatedly use the snap igniter? CURE Try to relight burner by holding burner control knob in and continue holding in until 20 seconds after burner has ignited. When relighting burner by holding burner control knob in, wait to see the entire ceramic surface become alight before counting 20 seconds? After waiting five minutes for gas to clear, try repeatedly using the snap igniter until the burner ignites (refer to "Lighting the Rotisserie Burner"). Try manually lighting the burner (refer to "Lighting the Rotisserie Burner"). Call customer service. General Symptoms: Burner does not light. -or- Burner has a small flickering flame The excess flow safety device, which is part of the barbecue to cylinder connection, may have activated. To reset the excess flow safety device turn all burner control knobs and the cylinder valve to "OFF". Disconnect the regulator from the cylinder. Turn burner control knobs to "START/HI". Wait at least 1 minute. Turn burner control knobs to "OFF". Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting Instructions". If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. OPERATING THE HANDLE LIGHT The Weber Grill Out™ Handle Light has a built-in "Tilt Sensor." With the power button (a) activated, the light will come on when the grill lid is open. The light will turn off when the lid is closed. For daytime use, deactivate the sensor by pressing power button (a). HANDLE LIGHT TROUBLESHOOTING PROBLEM CHECK CURE Weber Grill Out™ Handle Light does not light. Are the batteries old? Are the batteries installed correctly? Is the lid in the up position with the power button ON? Replace batteries. See assembly illustration. Light will activate when lid is open. Is the Weber Grill Out™ Handle Light activated? Press the power button. Is the Weber Grill Out™ Handle Light positioned correctly on the handle? Adjust position (See assembly illustration). If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. PROBLEM Side Burner does not light. Flame is low in "HI" position. Push button ignition does not work. SIDEBURNER TROUBLESHOOTING CHECK CURE Is gas supply off? Turn supply on. The excess flow safety device, which is part of the barbecue to cylinder connection, may have activated. To reset the excess flow safety device turn all burner control knobs and the cylinder valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to START/HI. Wait at least 1 minute. Turn burner control knobs to "OFF". Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting Instructions". Is the fuel hose bent or kinked? Straighten hose. Does burner light with a match? If match lights burner, check igniter (see Sideburner Maintenance). If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. WWW.WEBER.COM®