Weber Summit S-450 NG Owner Manual - Page 29
Side Burner Maintenance, Troubleshooting
View all Weber Summit S-450 NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
SIDE BURNER MAINTENANCE SIDE BURNER MAINTENANCE ƽ WARNING: All gas controls and supply valves should be in the "OFF" position. Make sure black wire is connected between the igniter and electrode. Make sure white wire is connected between the igniter and grounding clip. Spark should be a white/blue color, not yellow. 1) Igniter Wire 2) Ground wire 3) Burner Side Burner Grate Side Burner cap Side Burner Ring & Head Igniter Electrode Control Knob Igniter 29 29 PROBLEM Burners burn with a yellow or orange flame, in conjunction with the smell of gas (This is normal for the burner lighting tube). Symptoms: Burner does not light, or flame is low in "HI" position. Experiencing flare-ups: TROUBLESHOOTING CHECK Inspect Spider/Insect Screens for possible obstructions. (Blockage of holes.) Is fuel hose bent or kinked? Does Burner light with a match? Did you use the snap igniter several times until the main burner lit (See Lighting Instructions)? Does the igniter work (Do you see a spark when you repeatedly use the snap igniter? Are you preheating barbecue in the prescribed manner? CURE Clean Spider/Insect Screens. (See Section "Annual Maintenance") Straighten fuel hose. If you can light Burner with a match, then check the Crossover® ignition system. Make sure to hold the control knob in for two seconds after snapping the igniter and seeing the orange flame from the burner lighting tube. Try manually lighting the burner (refer to "Main Burner Manual Lighting"). Call customer service. All burners on HI for 10 to 15 minutes for preheating. Are the cooking grates and Flavorizer® bars heavily coated with burned-on grease? Clean thoroughly. (See Section "Cleaning") ƽ CAUTION: Do not line the bottom tray with aluminum foil. Is the bottom tray "dirty" and not allowing grease to flow Clean bottom tray. into catch pan? Burner flame pattern is erratic. Flame is low when Are burners clean? burner is on "HI". Flames do not run the whole length of the burner tube. Clean burners. (See Section "Maintenance".) Inside of lid appears to be "peeling." (Resembles paint peeling.) The lid is porcelain enamel or stainless steel, not paint. It cannot "peel". What you are seeing is baked on grease that has turned to carbon and is flaking off. THIS IS NOT A DEFECT. Clean thoroughly. (See Section "Cleaning".) Cabinet doors are not aligned. Check the adjustment pin on the bottom of each door. Loosen adjustment nut/s. Slide door/s until aligned. Tighten nut. If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. WWW.WEBER.COM®