Weber Platinum II 3200 NG Owner Manual - Page 19

Step 19 Install tool holders, control panel and burner control knobs You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs. Hook the tool holders over the frame rail. Figure 25. Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 25 (a). Push on the burner control knobs. Figure 25 (b). Insert in frame brace (a) Crossover Ignition Button Step 20 Secure side burner Pull the right hand swing table up. Stand to the right side of the barbecue. Slightly pull back both side burner locks. Slide the side burner toward the control panel. The locks will snap into the slots in the front and back of the side burner. Figure 26. ƽCAUTION: Make sure both locks have snapped into place. Tool holders Figure 25 Control panel Phillips screws/ washers (b) View from top View from side Figure 26 19