Weber Genesis 3500 LX Owner Manual - Page 18
Contact Weber-Stephen Customer Service. Do not use
View all Weber Genesis 3500 LX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Slide the cooking box to the left within the frame. Put the washer on the bolt. Take the spacer bracket and hold it up to the frame making sure both tabs fit underneath the frame cross piece. Figure 14 (a). Insert the bolt through the center hole in the spacer bracket, frame and cooking box with the head of the bolt outside the spacer bracket. Figure 14 (b). Add keps nut. Tighten by holding the bolt with pliers while you tighten the nut with the 7/16 inch wrench. Spacer (a) bracket Frame cross piece Your Weber Gas Barbecue burner assembly has been factory assembled, pressure and flame tested. As a safety precaution we recommend you check the burner alignment: a) Are the ends of the burners under the washers at the left rear and left front of the cooking box? The screws are only guides. Do not tighten. Figure 15 (a). b) Are the wing nuts under the burner assembly hand tight? Do not tighten with pliers. Figure 15 (b). If you answered YES to a and b, the burners are correctly aligned. If you answered NO, the burners are misaligned. Contact Weber-Stephen Customer Service. Do not use barbecue. Guide screw (b) Bolt Nylon washer Tab Keps nut (a) Figure 15 View from behind cooking box (b) Wing nuts Figure 14 18