Vtech vt1733 User Manual - Page 10
Getting Started
View all Vtech vt1733 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
GETTING STARTED SETTING UP AC POWER ADAPTER Plug the AC power adaptor into an electrical outlet and the DC connector to the back of the Base Unit. CHARGETHE HANDSET BATTERY PACK BEFORE USE. The battery pack recharges automatically whenever the Handset is in the Base Unit. The battery pack must be charged for 16 hours before using your phone for the first time. CONNECT THE TELEPHONE LINE CORD Plug one end of the telephone line cord into the jack on the back of the Base Unit, plug the other end of this cord into the wall jack. CAUTION: USE CLASS 2, 9V DC POWER SUPPLY ONLY. SETTING RINGER The Handset ringer is programmed ON as the factory default setting. To change ringer settings, see RINGER TONE / VOLUME. The Base Unit ringer is controlled independently, by a switch located on the front, right hand side (antenna side) of the Base. The Base ringer have 3 settings, High, Low and Off. TONE/PULSE SELECTION Your CB 1733 is preset for Tone dialing. If you have rotary (pulse) service, program the Handset accordingly. See SET TONE/PULSE for details. CHECK FOR A DIAL TONE After the battery is charged, rotate the Base Unit antenna to upright position. Now press PHONE on the Handset. PHONE ON will appear on the LCD, and you will hear a dial tone. If not, see IN CASE OF DIFFICULTY. Fill in the telephone number card on the Base Unit. CAUTION: 1. Never install telephone wiring dur- ing a lightning storm. 2. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. 3. Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. 4. Use caution when installing or modifying telephone lines. 10