Viper VSS3000 Owner Manual - Page 7

• The brake pedal is pressed. • The hood is opened. • The shutdown toggle switch is put into the OFF position • The pre-programmed run time has elapsed. • The procedure to activate remote start is repeated. Valet Take-Over The Valet Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful if you want to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on. To perform Valet Take-Over: 1. Before turning off the engine, send Remote Start command from your SmartStart application. 2. Turn the ignition key to the OFF position (The engine will stay running). 3. The engine will run until the pre-programmed time elapses or a shut-down input is received. (See the previous section for a complete list of shut-down inputs.) Note: This feature will not work if the brake pedal is being pressed. Starter Anti-Grind Circuitry Whenever the vehicle is remote started, advanced anti-grind circuitry prevents the starter from engaging, even if the key is turned to the start position. This prevents damage to the starter motor if the key is turned to the start position during remote start operation. Note: Anti-grind circuitry only works when the remote start system is op­er­at­ing the motor and the optional relay is installed. © 2010 Directed Electronics. All rights reserved. 3