Viper 5900 Owner Manual - Page 33
valet take-over - valet switch
View all Viper 5900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
When you are ready to drive the vehicle: 1. Insert the ignition key and turn it to the ON (not the START) position. 2. Press the brake pedal. note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down. While the vehicle is running during remote start operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shutdown inputs: ➤ The brake pedal is pressed. ➤ The hood is opened. ➤ The shutdown toggle switch is put into the OFF position. ➤ The pre-programmed run time (12, 24, or 60 minutes) has elapsed. ➤ Transmitter button is pressed again to start the vehicle. ➜ valet take-over The Valet® Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on. © 2006 directed electronics 29