Viper 571XV Owner Manual

Viper 571XV Manual

Get Viper 571XV PDF manuals and user guides View all Viper 571XV manuals
Add to My Manuals
Save this manual to your list of manuals

Viper 571XV manual content summary:

  • Viper 571XV | Owner Manual - Page 1
    Model 571XV ➤Owner's Guide
  • Viper 571XV | Owner Manual - Page 2
    replace with a comparable reconditioned model any Directed unit (hereafter the "unit"), excluding without limitation the siren, the remote unit has been damaged by accident, unreasonable use, neglect, improper service, installation or other causes not arising out of defects in materials or
  • Viper 571XV | Owner Manual - Page 3
    AUTHORIZED DIRECTED DEALER'S PURCHASE PRICE OF THE UNIT. DIRECTED MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL MODULE AS plan or call Directed Customer Service at 1-800876-0800. Directed address ➤ Type of alarm installed ➤ Year, make, model and color of the automobile
  • Viper 571XV | Owner Manual - Page 4
    notification 9 programming remote 10 using your system 11 warning! safety first 11 locking 13 unlocking 14 panic mode 16 valet mode 16 remote start 17 rear defogger 19 valet take-over 20 short-run/turbo 20 timer mode 22 auxiliary outputs (options 23 safety features 24 starter anti
  • Viper 571XV | Owner Manual - Page 5
    2 © 2005 directed electronics-all rights reserved
  • Viper 571XV | Owner Manual - Page 6
    LED indicator light ➤ A push-button Valet switch ➤ Your warranty registration ➤ A shut-down toggle switch important information Congratulations on the purchase of your 2-way remote start keyless entry system. Due to the complexity of this system, it must be installed by an authorized dealer only
  • Viper 571XV | Owner Manual - Page 7
    sure you receive the warranty registration from your dealer. It is also necessary to keep your proof of purchase, which reflects that the product was installed by an authorized dealer. ➜ fcc/id notice This device complies with Part 15 of FCC rules. Operation is subject to the following conditions
  • Viper 571XV | Owner Manual - Page 8
    2-way remote diagram 2 3 1 4 5 6 8 7 standard remote configuration 1. Unlock/Lock Indicator (Orange) 2. Receive/Transmit Indicator (Green) 3. Remote Start/Auxiliary Indicator (Yellow) 4. Panic Indicator (Red) 5. Lock Button 6. Unlock Button 7. Remote Start Button 8.
  • Viper 571XV | Owner Manual - Page 9
    2-way remote buttons. This makes it possible to assign any 2- way remote button to any receiver function. The 2-way remote initially comes programmed with Standard Configuration, but may also be customized by an authorized dealer. The buttons in all of the instructions in this manual correspond
  • Viper 571XV | Owner Manual - Page 10
    function, such as trunk release, can be controlled by pressing this button for 1.5 seconds.) The auxiliary output controls Button The remote start feature is turned On/Off by pressing this button twice. and Buttons The remote start timer mode function of the system is controlled by pressing these
  • Viper 571XV | Owner Manual - Page 11
    for 3-seconds to enter Panic Mode. and and Buttons When simultaneously pressed these buttons control the rear window defogger during remote starting. remote operation The remote start system operates at 434 MHz and incorporates Directed's proprietary XHF2 out-board technology transceiver. The
  • Viper 571XV | Owner Manual - Page 12
    100 seconds to alert the user that the security feature was triggered and will continue until the alarm page is cleared. Page Recognition To clear a page alert/notification, quickly press any button on the remote control. This can be performed at any time during or after the page notification has
  • Viper 571XV | Owner Manual - Page 13
    programming remote To enter programming mode Press and hold all four remote control buttons simultaneously until one long beep is heard. Programming mode is now entered. Beeps On/Off Press to select beeps On/Off. One beep is notification beeps On, Two beeps is notification beeps Off.
  • Viper 571XV | Owner Manual - Page 14
    or partially enclosed area or when having the vehicle serviced, the remote start system must be disabled using the installed toggle switch. It is the user's sole responsibility to properly handle and keep out of reach from children all 2-way remotes to assure that the system does not unintentionally
  • Viper 571XV | Owner Manual - Page 15
    car is in gear. This testing should be performed by an authorized Directed dealer in accordance with the Safety Check outlined in the product installation guide. If the vehicle starts in gear, cease remote start operation immediately and consult with the authorized Directed dealer to fix the problem
  • Viper 571XV | Owner Manual - Page 16
    OF AN AUTHORIZED Directed DEALER TO REPAIR OR DISCONNECT THE INSTALLED REMOTE START MODULE. DIRECTED WILL NOT BE HELD RESPONSIBLE OR PAY FOR INSTALLATION OR REINSTALLATION COSTS. ➜ locking Pressing for one second arms the system by activating the starter kill and locking the doors (if the door locks
  • Viper 571XV | Owner Manual - Page 17
    same time that the Failsafe® Starter Kill is activated. If Passive Locking is programmed on, care must be taken to prevent the keys from being locked in the vehicle. note: For Passive Mode to be effective, the Failsafe® Starter Kill relay must be installed. The remote responds to active arming with
  • Viper 571XV | Owner Manual - Page 18
    a 2-way remote If your 2-way remote is lost or damaged, you can manually override the starter kill. To do this, you must have the vehicle's ignition key and know where the Valet button is located. Be sure to check with your installer at the time of installation for the location of the Valet button
  • Viper 571XV | Owner Manual - Page 19
    useful when washing the vehicle or having it serviced. In Valet Mode, the starter kill cannot be activated, even with the 2-way remote, but all convenience functions (door locks, remote start, etc.) will continue to work normally. To enter or exit Valet Mode: 1. Turn the ignition On. 2. Turn the
  • Viper 571XV | Owner Manual - Page 20
    your vehicle when the keys are in the ignition, except when performing Valet® Take-Over, and (2) Never start the vehicle if it is not in either PARK or NEUTRAL. To remote start the vehicle: 1. Press on the 2-way remote twice within 3 seconds. 2. The parking lights will flash to confirm that the
  • Viper 571XV | Owner Manual - Page 21
    or 60 minutes - see Programming Options section of this guide) or until a shutdown input is triggered. For a remote start, the remote responds with remote start tones and the Yellow LED illuminates for 3-seconds. For a remote start Off, the remote responds with remote start off tones and the Yellow
  • Viper 571XV | Owner Manual - Page 22
    is put into the OFF position. ➤ The pre-programmed run time (12, 24, or 60 minutes) has elapsed. ➤ 2-way remote button is pressed twice again to stop the engine. ➤ The remote responds with remote start off tones and the Yellow LED flashes 3-times. ➜ rear defogger To turn the rear defogger output
  • Viper 571XV | Owner Manual - Page 23
    note: If the remote start is on the lights will turn off then flash 3-times before returning to their normal output and the defogger output will activate as programmed. ➜ valet take-over The Valet Take-Over feature allows the vehicle to remain running after the key has been removed from the
  • Viper 571XV | Owner Manual - Page 24
    running. 3. Press and release the and buttons at the same time. 4. The remote start responds with remote start tones and the Yellow LED is illuminated . 7. The engine will turn off after the programmed run time. The remote responds with remote start tones and the Yellow LED illuminates for 3-seconds.
  • Viper 571XV | Owner Manual - Page 25
    the vehicle will start. 4. The system will start the car and will run for the specified dura- tion, unless shut down by the remote start button . 5. The system will start every 3 hours (for a maximum of 6 starts) until canceled by the brake, hood, or neutral safety shut-down wires. On entering Timer
  • Viper 571XV | Owner Manual - Page 26
    lid. for 1.5 Channel 4 auxiliary output: When connected, pressing and will immediately activate this output to control an additional convenience option. The remote will respond with a page notification consisting of an output tone (once) and the Yellow LED will flash 3-times. This occurs at the
  • Viper 571XV | Owner Manual - Page 27
    and the Failsafe® Starter Kill relay is installed. ➜ disabling the remote start system This feature allows your system's remote start unit to be temporarily disabled to prevent the vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in
  • Viper 571XV | Owner Manual - Page 28
    other problems which may cause the engine to race. note: The system uses a wire connected to the vehicle to sense engine speed. This wire must be connected in order for over and under rev protection to work. ➜ shut down inputs This system uses several inputs to shut down the remote start operation
  • Viper 571XV | Owner Manual - Page 29
    the system settings. The programmer makes it possible to program different settings for each 2-way remote that is used with the system. Then, when- ever a specific 2-way remote is used, the system will recall the settings assigned to that 2-way remote. Owner Recognition lets up to four users of
  • Viper 571XV | Owner Manual - Page 30
    for each user. note: Owner Recognition cannot be programmed without a Bitwriter and the necessary software. Check with unit is in Valet Mode and the battery is disconnected for any reason, such as servicing the car, when the battery is reconnected the unit will still be in Valet Mode. This applies
  • Viper 571XV | Owner Manual - Page 31
    off. If your installer is programming the security system with the Directed Bitwriter, ignition lock and unlock are independent features that can be programmed separately. ➤ Passive door locking (with passive arming) or active door locking (only when locking with the 2-way remote). Passive locking
  • Viper 571XV | Owner Manual - Page 32
    6, 9, or 12 minute timer mode run time. Your system can be programmed to allow the vehicle to run for 3, 6, 9, or 12 minutes when remote started in timer mode. Can be set up to 16 minutes by your installer. ➤ While the remote start system is running the engine, the parking lights of the vehicle can
  • Viper 571XV | Owner Manual - Page 33
    time the system is unlocked using the 2-way remote. This is useful for seeing inside the , leaving the passengers doors locked. Pressing the unlock button an additional time will unlock the passenger doors. This secu- rity system programming and zone trigger information. 30 ©
  • Viper 571XV | Owner Manual - Page 34
    at a discretionary location inside the vehicle. It is used to indicate the status of your system. Valet® Button: A small push-button switch mounted at a discretionary location inside the vehicle. It is used to override the starter interrupt when a 2-way remote is lost or damaged, or to enter or exit
  • Viper 571XV | Owner Manual - Page 35
    32 © 2005 directed electronics-all rights reserved
  • Viper 571XV | Owner Manual - Page 36
    . Press and release the Valet button within 10 seconds. The LED will stop flashing and the vehicle should start. To remote start the vehicle ■ Press twice within 3 seconds. The parking lights will turn on (if connected) and the vehicle will start and run for the programmed duration. To enter or
  • Viper 571XV | Owner Manual - Page 37
    OFF position. Once the vehicle has started, it will run for the pre-programmed period of time (12, 24, or 60 minutes). Rear Window Defogger ■ Press the , and buttons simultaneously to turn the defogger on or off when remote starting. When a remote start is initiated, the parking lights will flash
  • Viper 571XV | Owner Manual - Page 38
    all rights reserved
  • Viper 571XV | Owner Manual - Page 39
    , to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly information about our products and services. Directed Electronics is committed to delivering world class quality products and services that excite and delight our
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
Model 571XV
➤
Owner’s Guide