Viper 106V Owner Manual - Page 10
will repeat once.
View all Viper 106V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
3. Wait 5-seconds. 4. The LED will illuminate continuously for 3-seconds. 5. The LED will then extinguish for 1.5 seconds. 6. The LED will then flash 10 times (0.5 second on, 0.5 second off). 7. The LED will turn off for 2-seconds. 8. The LED will then flash in 10 flash cycles repeatedly (as described in step 6 and step 7). 9. To enter the first digit of your PIN code it is necessary to turn the ignition Off once the number of flashes equals the first digit of your PIN (during the 10-flash cycle described in step 6). If you miss the count, let the system continue to the next 10-flash cycle. 10. The LED will flash to indicate the number you selected. This will repeat once. 11. Turn the ignition back On (the LED will begin flashing in groups of 10 again). 12. Repeat steps 9, 10, and 11 for the 2nd, 3rd and 4th digit of the PIN number. 13. Once the 4-pin code is entered correctly, the system will disarm and the LED will extinguish. note: For example, turning the ignition Off after the first flash of the 10 flash cycle, enters a number of one (1). Turning the ignition Off after the 4th flash, enters a number of four (4). Turning the ignition Off after the 10th flash, enters a number of zero (0). note: If the entered code is incorrect, the LED will illuminate continuously for 3-seconds and the system will exit Disarming Without a Touch Key mode. You will have to start from the beginning again to enter the correct code. © 2004 directed electronics, inc. 7