Viking VQGFS5301 Installation / Use and Care Instructions - Page 18

GAS CONNECTIONS ...continued Insert the regulator inlet into the cylinder valve and turn the black coupler clockwise until the coupler is hand tight. Do not over-tighten this connection. To disconnect the coupler, first make sure the main cylinder valve is turned off. Grasp the coupler and turn counter clockwise. The inlet will then disengage. Always leak-test the connection after refilling or exchanging LP cylinders. (See INDEX: "Leak Test" for further details.) GAS LINE PURGING You should purge the gas line of air before attempting to light the grill. • Make sure all grill controls are in the "OFF" position. CART INSTALLATION • Shut off the gas supply at the main valve. • Disconnect all plumbing (if already attached) from the grill and the gas supply valve. • Remove all the fittings from the grill manifold. • Install the side burner onto the cart according to the directions supplied with the cart mounting kit. • Connect the gas supply to the grill and the side burner as shown in the diagrams on this page for your gas type. • Turn the gas supply on and leak test all connections. (See INDEX: "Leak Test" for further details.) • Slowly turn on the main gas supply. • Push in the rotisserie knob and confirm that the igniter is glowing. It is furthest from the fuel source and will completely purge the lines. It will take several seconds for the burner to light. • Hold the knob ON for about 20 seconds to allow the air in the system to purge and the burner to light • Wait at least 5 minutes after shutting off the control before attempting to light the burners. GAS CONVERSION KITS Gas conversion kits are available from Viking Range, LLC to allow the grill to operate on either Natural gas or LPG. These kits should be installed by a qualified technician. The kits come with complete installation instructions. These instructions should be read completely and fully understood before installing the conversion kit. BUILT-IN SIDE BURNER INSTALLATION • Shut off the gas supply at the main valve. • Disconnect all plumbing (if already attached) from the grill and the gas supply valve. • Remove all the fittings from the grill manifold. • Install the side burner into the counter top cutout. • Connect the gas supply to the grill and side burner as shown in the two diagrams on this page. • Turn the gas supply on and leak test all connections. (See INDEX: "Leak Test" for further details.) | 18 INSTALLATION / USE & CARE