Viking VCBB363RSS Installation Instructions - Page 24

Performance Checklist - icemaker

Get Viking VCBB363RSS PDF manuals and user guides View all Viking VCBB363RSS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Final Installation 28 29 Performance Checklist Replace top air grille. 30a Using an 8" magnetic nut driver, replace the two 1/4" screws. 30b (Professional) Replace the center grille louver. 31 (Designer) Replace the center grille louver. 32 Open door. Display should flash. Press "ACTIVATE CONTROLS" pad and close door. NOTE: There is a 6 minute delay before the unit starts. 46 h Verify cabinet size. h Verify electrical supply and water supply (if applicable). h Install anti-tip device(s) and verify unit is secure. h Position unit in cutout, level at desired height and secure unit. h Plug-in unit and verify operation. h Connect water supply (if applicable). • Verify icemaker fill tube is properly inserted. • Verify icemaker bail arm is down. • Verify dispenser operation (if applicable). h Align/square door(s). h Verify drain pan is properly installed and no leaks on water connection. h Install kickplate. h Remove internal packaging and labels and wipe unit down. Installer's information: Installer's name Installer's company Date 47

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
47
46
Replace top air grille.
Using an 8” magnetic nut driver, replace
the two 1/4” screws.
(Professional) Replace the center grille louver.
(Designer) Replace the center grille louver.
Open door. Display should flash.
Press “ACTIVATE CONTROLS” pad and close door.
NOTE:
There is a 6 minute delay before the unit starts.
28
29
30a
30b
31
32
Final Installation
Performance Checklist
h
Verify cabinet size.
h
Verify electrical supply and water supply
(if applicable).
h
Install anti-tip device(s) and verify unit is
secure.
h
Position unit in cutout, level at desired
height and secure unit.
h
Plug-in unit and verify operation.
h
Connect water supply (if applicable).
• Verify icemaker fill tube is properly
inserted.
• Verify icemaker bail arm is down.
• Verify dispenser operation
(if applicable).
h
Align/square door(s).
h
Verify drain pan is properly installed and
no leaks on water connection.
h
Install kickplate.
h
Remove internal packaging and labels
and wipe unit down.
Installer’s information:
Installer’s name:
_____________________________
Installer’s company:
_________________________
Date:
________________________________________