Viking VBBO2602SS Installation Instructions - Page 2

IMPORTANT - PLEASE READ AND FOLLOW •Before beginning, please read these instructions completely and carefully. •Do not remove permanently affixed labels, warnings, or plates from product. This may void the warranty. •Viking outdoor stainless steel cabinets are not designed to be water tight. Water may enter cabinetry under certain conditions •The installer should leave instructions with the consumer who should retain for future reference •NEVER use LP tanks inside any stainless steel cabinetry. Tanks must be located outside of the cabinetry at all times. TO INSTALL CABINETS: 1. Verify cabinet product number(s) on box(es) to list of cabinets ordered. 2. Carefully unpack cabinets making sure not to scratch fronts. Front panels are protected by plastic coating (that must be removed after setup). Cabinets with interchangeable doors are shipped from the factory with opening from left to right as shown (See illustration #1). Illustration #1 3. In cabinets with interchangeable doors, hardware package will contain hole covers and hardware to install. 4. Install 4 legs in the leg plates attached to bottom of each cabinet. Screw in place. (See illustration #2). Illustration #2 Cabinet box ready for assembly 2 5. Place cabinet(s) in approximate final position. Level cabinets using leveling legs. Use 1/2" SMS screws provided to screw cabinets together. (See illustration #3). Illustration #3 Install 4 Tinnerman clips (provided) before fastening cabinets together Mount cabinets with #10 x 1/2" screws provided 6. Determine appropriate hinge side for cabinets with interchangeable doors. Remove outside door panel. Install hinges by placing plate in hole in door and fasten in place with hardware provided. Screw hinge plates in appropriate pre-drilled holes in cabinet side. Fasten hole covers with hardware provided. (See Illustration #4). Illustration #4 Use #8 x 3/8" machine screw and locknut to fasten hole cover to inside door panel 7. Cabinet doors must be adjusted when cabinets are level in final position. There are two adjustment screws on the hinge receiver. (See Illustration #5) •The front screw is used to center the door in the opening. Turning the front screws in or out will center the door over the cabinet opening. •The back screw is used to align the front of the door with the cabinet frame and secure the door to the cabinet. Slightly loosen the screw and slide door in or out. Retighten the screw to secure the door. Illustration #5 3 Use #8 x 3/8" flat head M.S. and locknut to attach hinge bracket to the inside door. Back Screw Front Screw