Viking DUAR1541CRSS Installation Instructions - Page 5

Custom Wood Frame Installation Instructions (DFUR Model) Note: Weight of wood panel must not exceed 20 lbs. Step 1: Verify door alignment The door should be parallel to the sides and top of the refrigerator. If alignment is necessary the door may be adjusted by loosening the 2 screws which secure the hinge adapter brackets to the door and adjusting the door side to side. Use a 5/32" allen wrench for this procedure. (See Figure 1 below). Hinge adaptor screws Loosen these to adjust door, on the top and bottom of the door Top hinge pin Remove to remove the door Door must be parallel to top and sides of refrigerator 9/32" (7 mm) Figure 1 Step 2: Remove door Remove the top hinge pin from the hinge with an 1/8" allen wrench. Remove the door by angling the top of the door outward and lifting the door off the bottom hinge. (See detail in Figure 1). Step 3: Remove gasket Lay the door on its front being careful not to scratch it. Remove the door gasket by peeling up and out of the channel. Step 4: Cut overlay panel Depending on the refrigerator model cut the overlay panel to the dimensions shown. Use Figure 2 and Table A. Note: For the door closer to work properly, it is necessary to maintain a minimum space of 9/32" (7mm) between the door and cabinet flange as shown. This space can be adjusted by adjusting the top and bottom hinge adapters. 8 Custom Wood Frame Installation Instructions (DFUR Model) (cont.) W H Front of overlay panel 1-23/32" (38.8 cm) Typical 4 Sides Model 15" 24" W 14-5/16" (36.4 cm) 23-7/16" (59.5 cm) H 30-5/16" (76.9 cm) 30-5/16" (76.9 cm) Table A Glass Door Models Figure 2 Glass Door Models Step 5: Clamp panel to door Set the overlay panel on the door front, align the edges, and clamp together. Clamp the panel firmly but be careful not to crush the foam in the door or scratch the door. Step 6: Drill holes in overlay panel Remove the hinge adapter bushings from the top and bottom door hinge adapters. (See Figure 4). Using the holes in the hinge adapters drill 5/16" (8 mm) diameter clearance holes into the overlay panels 3/4" (20 mm) deep. These will be clearance holes for the top and bottom hinge pins. Also, at this time, drill the screw pilot holes for attaching the overlay panel to the door. Select the size of the hole from Table B. Be careful not to drill the pilot holes through the overlay panel but only 1/2" (12.7 mm) deep. Material Type Hardwood Softwood #8 Wood Screw 3/32" (2.4 mm) Diameter. Pilot Hole 5/64" (2.0 mm) Diameter. Pilot Hole Table B 9