Vantec NST-371C31-BK Manual - Page 1

USB-C to A cable USB-C to C cable 3.5" HDD mounting (Longer) Rubber screws x 4 Feet 2.5" HDD mounting (Shorter) screws x 4 Tray mounting (Shorter) screws x 4 1. Verify the package contents Screw driver For 2.5", place drive show and slide drive towards SATA interface. Make sure SATA interface on both drive and enclosure are connected securely and secure using 4 short screws from the underside. Tray underside Back Power conector USB3.1 ON/OFF DC 12V USB-C ON/OFF Activity Power Switch LED Front Top 2. Parts Layout For 3.5", place drive show and slide drive at an angle towards SATA interface until the drive can place flat down into the tray. Once laying flat, push the drive in the direction of the SATA interface to connected securely. Secure using 4 long screws from the side (two on each side). USB 3.1 Gen 2 Type-C 3.5" SATA HDD/SSD Enclosure SATA Interface 2.5" hard drive mounting holes from the bottom up 4 x screws NexStar® GX 3.5" enclosure Model : NST-371C31-BK Made in China Bottom 3.5" hard drive mounting holes on sides 4 x short screws NexStar® GX 3.5" enclosure Model : NST-371C31-BK Made in China Align Tray mounting hole on the bottom and secure with 4 short screws design for the enclosure 3a. Secure SATA Hard Drive into Tray Use the USB Type C to C cable Computer with USB Type-C port 5a. If your Computer comes with USB-C port 3b. Secure SATA Hard Drive into Tray 4. Secure Tray to enclosure housing After securing the enclosure, use the rubber feet provided to cover up the screw holes Use the USB Type C to A cable Computer with USB Type-A port 5b. If your Computer comes with USB-A port You can connected and disconnect USB devie without shutting down the system. When disconnecting this enclosure from your system, please use USB "Safe to Remove" function to eject before unplugging the USB device. If you install a new hard drive into the enclosure, please initialize, partition and format the drive using the OS system tools before you can use it. For Windows System, use Disk Management. For Apple OS X system, use Disk Utility. If System is not recognizing the connected USB device, try the following: a) Check both ends of the connection, the Enclosure and the System for loose connection. b) Try other USB ports. c) Try a di erent computer to see if the problem is related to this computer USB port problem. d) Use OS system tool to check the status of the physical disk in disk management or disk utility. NST-371C31-BK Copyright © 2018 Vantec Thermal Technologies. All Rights Reserved. All Registered Trademarks Belong to Their Respective Compaines.