Tripp Lite B110SPPOE Quick Start Guide for B110-SP-POE English - Page 4

Installation Multiple Device Protection: Note: The max distance between any two In-Line 1G PoE Surge Protectors is 328 ft. (100 m). 1. Disconnect the installed patch cable from both of the devices you wish to protect. 2. Connect an In-Line 1G PoE Surge Protector to each end of the previously uninstalled patch cable, ensuring both ends of the patch cable are connected to the "Cable End" of the In-Line 1G PoE Surge Protector. 3. Using Cat5/5e/6 patch cables (not included), connect the "Equipment End" of each In-Line 1G PoE Surge Protector to the PoE device and equipment you wish to protect. Note: For the best protection performance, the Cat5/5e/6 patch cable between the "Equipment End" of the In-Line 1G PoE Surge Protector and the PoE equipment to be protected should not exceed 300 ft. (90 m). Tripp Lite's N001-Series Cat5e Snagless Patch cables are recommended. 4. Connect the ground wire to each In-Line Surge Protector and then to earth ground. IP Phone PoE Camera PoE Equipment (Protected) OR Equipment End Cable End 328 ft. (100 m) Max Cable End Equipment End 20-06-207-93389F-EN.indd 4 PoE Sources (Protected) OR PoE Hub PoE NVR 4 6/24/2020 4:14:57 PM