Thermador PODMCW31W Installation Instructions - Page 3

Connecting the Microwave to the, Lower Oven, Microwave Models, Installation of the Microwave to,

Get Thermador PODMCW31W PDF manuals and user guides View all Thermador PODMCW31W manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

4. Snap the conduit connector into the hole by pressing it in until it clicks into place. 5. Follow the wiring diagram label (see image below) and match and connect each wire by color to the wires attached to the wiring block inside the oven-mounted junction box. Push the bare end of the wire until it is snug in the wiring block then tighten down the retaining screw on each wire. Tighten securely, but do not overtighten. See previous illustration in Step 3 for finished appearance. 6. Replace the oven-mounted junction box cover and tighten the two screws holding it in place. Tighten securely, but do not overtignten. Connecting the Microwave to the Lower Oven Note: When installing the combination unit, the microwave power cord must be properly attached to the 120V receptacle. This must be done prior to supplying electrical power to the oven unit. A WARNING Check to be sure that no electrical power has yet been supplied to the oven. Microwave Models MEM301WS POM301W Installation of the Microwave to the Lower Oven Plug the microwave power cord into the 120V receptacle located on top of the lower oven. (See illustration below.) Customer Service The model number and the FD number of your appliance are found on the rating label. Make a note of these numbers to save time in the event further customer service is needed. Consult your Use and Care Guide for the specific label location. To contact Customer Service: US: 800-735-4328 Web: www.thermador.com/support Parts & Accessories: www.thermador-eshop.com 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
See previous illustration in Step 3 for
finished appearance.
6.
Replace the oven-mounted junction box cover and
tighten the two screws holding it in place.
Tighten securely, but do not overtignten.
4±
Snap the conduit connector into the hole by pressing it
in until it clicks into place.
5±
Follow the wiring diagram label (see image below) and
match and connect each wire by color to the wires
attached to the wiring block inside the oven-mounted
junction box. Push the bare end of the wire until it is
snug in the wiring block then tighten down the
retaining
screw on each wire.
Tighten securely, but do not overtighten.
Connecting the Microwave to the
Lower Oven
Note:
When installing the combination unit, the
microwave power cord must be properly attached to
the 12
0V
receptacle. This must be done prior to
supplying electrical power to the oven unit.
A WaRNING
Check to be sure that no electrical power has
yet been supplied to the oven.
Microwave Models
MEM3
0
1WS
P
O
M301
W
Installation of the Microwave to
the Lower Oven
Plug the microwave power cord into the 120V
receptacle located on top of the lower oven.
(See illustration below.)
Customer Service
The model number and the FD number of your appliance are found on the rating label.
Make a note of these
numbers to save time in the event further customer service is needed.
Consult your Use and Care Guide for the
specific label location.
To contact Customer Service:
US: 800-735-4328
Web: www.thermador.com/support
Parts & Accessories: www.thermador-eshop.com
3