TASCAM IF-FW/DM :DM Owners Manual - Page 4
Installing the IF-FW/DM, Con For Your Mixer
View all TASCAM IF-FW/DM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
OInstallation Configure For Your Mixer There is a series of jumpers on the IF-FW/ DM that set its operating mode. These jumpers must be in the correct position to operate with a DM-3200 or DM-24, which communicate with the IF-FW/DM via different operating modes. Early IF-FW/DM cards shipped configured for the DM-24. From the time of DM-3200 software version 1.20 availability, IF-FW/ DM cards began shipping configured for the DM-3200. Please confirm your card's configuration with the following pictures and instructions then make any necessary changes before installing the IF-FW/DM into your mixer. NOTE • The IF-FW/DM will not function if incorrectly configured for your mixer. Installing an incorrectly configured card will not harm anything. • The IF-FW/DM must be installed in either mixer's Slot 1. It will not function in Slot 2. Use commonly available needle-nose pliers to carefully change the configuration of the card as shown. U43 U43 U42 U42 U41 U41 U40 U40 Picture 1 is IF-FW/DM Configured for a DM-3200. Note that jumpers J11 through J43 aFroer DaMc-r3o2s0s0 pin rows 2 and 3. J11 - J43 SDT : 1-2 (default) LVDS : 2-3 1 2 3 3 2 1 Card edge Picture 1 Picture 2 is IF-FW/DM Configured for a DM-24. Note that jumpers J11 through J43 are across pin rows 1 and 2. For DM-24 J11 - J43 SDT : 1-2 (default) LVDS : 2-3 1 2 3 3 2 1 Card edge Picture 2 U39 U26 U39 U26 U38 U25 U38 U25 U37 U24 U37 U24 U36 U23 U36 U23 U22 U35 U22 U35 U21 U34 U21 U34 U20 U32 U20 U32 U19 U31 U19 U31 U30 U18 U30 U18 U29 U17 U29 U17 U28 U16 U28 U16 U27 U15 U27 U15 U14 U14 U13 U13 U12 U12 U11 U11 Installing the IF-FW/DM 1. Remove the five screws holding the blank plate or card currently installed in Slot 1 then remove the plate or card. 2. Insert the IF-FW/DM into Slot 1, making sure that the card edges slide into the white plastic guide inside Slot 1. Push it all the way in until it clicks and the card back plate is flush with the mixer's back panel. Excessive force is not required - if it does not click in easily, remove it and TASCAM IF-FW/DM Owner's Manual start again with attention to the guides. 3. Replace the five screws to hold the card in place. NOTE • The IF-FW/DM must be installed in to the mixer's Slot 1. It will not function in Slot 2. • The following installation must be done with the mixer's power OFF and disconnected.