Sub-Zero 427R Wine Storage Installation Instructions - Page 11
Level the Unit, Home Alarm Connections, Models 424G and 424FSG Installation - stripes
View all Sub-Zero 427R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Models 424G and 424FSG Installation 11 subzero.com Level the Unit Using an adjustable wrench or pliers, turn each of the four leveling legs clockwise to raise the unit and counterclockwise to lower the unit. Refer to the illustration below for location of the leveling legs. For model 424G, the countertop bracket should be used to make a solid installation. Refer to the illustration on page 8. If this is not possible, wedge shims along the sides and top. To reduce the possibility of the unit tipping forward, the front leveling legs must be in contact with the floor. Home Alarm Connections Before the kickplate is installed, all necessary wiring connections in the compressor compartment should be completed. If a home alarm system is to be installed on the wine storage unit, the connections should be made using the logic supplied with the alarm specifications. Refer to the illustration for the appliance lead locations, and refer to the following for color codes: • Normally open contacts - white with red stripe wire • Normally closed contacts - white with blue stripe wire • Common - gray with white stripe wire Use the 1/4" spade terminals or wire nuts provided to make the proper wiring connections. IMPORTANT NOTE: If you are not responsible for alarm system connection, this information should be supplied to the home security system contractor. LEVELING LEGS Leveling legs. HOME ALARM CONNECTIONS Home alarm connections. The alarm circuit in the unit is intended as a lowvoltage, low-current device only. It should not be used to switch line power. Any unused terminals should be completely insulated and all wires should be secured away from conductive or moving components.