Stihl TS 410 STIHL Cutquik174 Product Instruction Manual - Page 28
Remove the V-belt
![]() |
View all Stihl TS 410 STIHL Cutquik174 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
English Removing the V-belt guard Remove the "cast arm with guard" 2 1 370BA071 KN N Remove screw (1) N Raise the V-belt guard (2) slightly and pull it off to the front 3 21 4 3 N Remove the V-belt (3) from the front pulley (4) 370BA079 KN 1 1 N Unscrew the nuts (1) N Remove the "starter cover with rewind starter" (2) N Remove the "cast arm with guard" (3) from the studs Preparing the "cast arm with guard" for outboard mounting 1 N Unscrew stop pin (1) 370BA073 KN 370BA072 KN 370BA074 KN A 1 45 32 N Turn the guard so that it is in the position shown (see picture) N Screw in and tighten the stop pin (1) N Move the adjusting lever (2) to position A N Screw in the bolt (3) and tighten up N Unscrew the bolt (4) of the limit stop (5) N Remove the limit stop (5) 6 370BA075 KN 45 N Turn the "cast arm with guard" so that the guard is on the outboard side N Insert limit stop (5) - align the hole in the limit stop with the hole in the cast arm N Screw in the bolt (4) and tighten up 26 TS 410, TS 420
![](/manual_guide/products/stihl-ts-410-stihl-cutquik174-product-instruction-manual-2e19b9e/28.png)